Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

RCA Lyra X2400 Microphone Replacement

Cosa ti serve

  1. RCA Lyra X2400 Microphone Replacement, Battery: passo 1, immagine 1 di 3 RCA Lyra X2400 Microphone Replacement, Battery: passo 1, immagine 2 di 3 RCA Lyra X2400 Microphone Replacement, Battery: passo 1, immagine 3 di 3
    • Using slight pressure with your finger on the word "OPEN", slide the battery plate down.

    • Remove the battery plate.

    • Place your finger at the bottom of the battery.

    • Lift up on the battery until it pops out from the LYRA X2400.

  2. RCA Lyra X2400 Microphone Replacement, Screen: passo 2, immagine 1 di 2 RCA Lyra X2400 Microphone Replacement, Screen: passo 2, immagine 2 di 2
    • Remove the two Phillips screws from the silver cover at the top of the Lyra.

    • Slowly wiggle the silver cover while pulling it away from the device.

  3. RCA Lyra X2400 Microphone Replacement: passo 3, immagine 1 di 2 RCA Lyra X2400 Microphone Replacement: passo 3, immagine 2 di 2
    • Remove the two Phillips screws from the bottom of the device, next to the charger port and Compact Flash release button.

    • Pull the silver case from the bottom of the device.

  4. RCA Lyra X2400 Microphone Replacement: passo 4, immagine 1 di 3 RCA Lyra X2400 Microphone Replacement: passo 4, immagine 2 di 3 RCA Lyra X2400 Microphone Replacement: passo 4, immagine 3 di 3
    • Carefully pry up the screen with a plastic opening tool.

    • Disconnect the screen's ribbon cable from the circuit board.

    • Remove the screen.

  5. RCA Lyra X2400 Microphone Replacement, Motherboard: passo 5, immagine 1 di 2 RCA Lyra X2400 Microphone Replacement, Motherboard: passo 5, immagine 2 di 2
    • Open the case of the Lyra.

    • Remove the four screws that secure the motherboard to the frame of the Lyra X2400.

  6. RCA Lyra X2400 Microphone Replacement, Microphone: passo 6, immagine 1 di 1
    • Locate the microphone component on your Lyra X2400. If you are having difficulty locating this component the picture to the left will show you where it is located.

    • Start using solder/desolder tools to remove the microphone.

    • Once removed replace it with the new working microphone.

    • Use the soldering tools to reattach the component back to the main logic board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Joseph Goodwin

Membro da: 04/11/13

1 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 17-3, Regan Spring 2013 Membro di Cal Poly, Team 17-3, Regan Spring 2013

CPSU-REGAN-S13S17G3

4 Membri

8 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 177