Introduzione

This guide will instruct you to replace the onboard microphone if it is faulty.

  1. Lift the metal flap and slide  the viewfinder off to the right.
    • Lift the metal flap and slide the viewfinder off to the right.

    Aggiungi Commento

  2. Unscrew the 7.0mm ph#0 screw on the underside where the cable connects.
    • Unscrew the 7.0mm ph#0 screw on the underside where the cable connects.

    • Lift the plastic where the cable is connected to the viewfinder.

    • Disconnect the cable inside by pulling it apart.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Unscrew the two 7mm ph#0 screws on the underside of the viewfinder assembly.

    • Lift the viewfinder plastic assembly up.

    Aggiungi Commento

    • Lift the microphone circuit board straight up.

    • Unclip the cable connected to the circuit board.

    Aggiungi Commento

    • Turn the microphone circuit board over.

    • Unscrew the two Ph#0 screws holding the plastic housing on the circuit board.

    Aggiungi Commento

    • Desolder the metal protective housing using a soldering iron.

    • Desolder the microphone and replace it.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Oliver Adams

Membro da: 19/01/2011

620 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 5-20, Amido Winter 2011 Membro di Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 703