Introduzione

This guide will instruct you to replace the effect button circuit board on the RCA CC310.

  1. Remove the 6-7.9mm ph#0 screws on the back and bottom. Remove the one 3.8mm ph#0 screw on the bottom.
    • Remove the 6-7.9mm ph#0 screws on the back and bottom.

    • Remove the one 3.8mm ph#0 screw on the bottom.

    • Remove the two 7.5mm ph#0 screws on the back and bottom.

  2. Remove 5.8mm ph#1 screw from the side button panel. Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.
    • Remove 5.8mm ph#1 screw from the side button panel.

    • Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.

  3. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  4. Pry along the seam on the top side near the buttons with a spudger. Pry along the seam on the top side near the buttons with a spudger.
    • Pry along the seam on the top side near the buttons with a spudger.

  5. Pull the left panel away from the rest of the camcorder. Unplug the red speaker cable located at the rear of the device.
    • Pull the left panel away from the rest of the camcorder.

    • Unplug the red speaker cable located at the rear of the device.

    • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

  6. Unplug the two cables on the bottom of the effect button circuit board. Unplug the cable at the top left side of the motherboard.
    • Unplug the two cables on the bottom of the effect button circuit board.

    • Unplug the cable at the top left side of the motherboard.

  7. Pull the plastic tabs away from the circuit board. Pull the board away from the camcorder. Use a spudger to help push the mini-circuit board away from the camcorder at the same time.
    • Pull the plastic tabs away from the circuit board.

    • Pull the board away from the camcorder.

    • Use a spudger to help push the mini-circuit board away from the camcorder at the same time.

    • Unplug the cable in the middle of the effects board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Oliver Adams

Membro da: 19/01/2011

620 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 5-20, Amido Winter 2011 Membro di Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Membri

7 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,374