Protocol Galileo Stealth Light Emitting Diode (LED) Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

This guide will walk you through how to replace the light emitting diodes (LED) on the drone. Minimal tooling is required, but the risk of damaging the drone is greater then many of the other guides if each step is not followed and executed with extra care.

Cosa ti serve

Passo 1 Housing

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Housing: passo 1, immagine 1 di 2

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Housing: passo 1, immagine 2 di 2

Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.
Take care to place the screws in a safe place to prevent losing them.

Traduci

Passo 2

Separate the upper and lower housing units by lightly pulling the two housing units apart.

Traduci

Passo 3 Light Emitting Diode (LED)

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Light Emitting Diode (LED): passo 3, immagine 1 di 1

Remove 6mm Phillips #0 screw from the LED strip.

Traduci

Passo 4

Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.
Take care not to damage the LED strip when removing it from the lower housing.

Traduci

Passo 5

Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.
Avoid damaging the wire plug, wires, and motherboard when removing the wire plug.

Traduci