Salta al contenuto principale

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement

Cosa ti serve

  1. Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Housing: passo 1, immagine 1 di 2 Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Housing: passo 1, immagine 2 di 2
    • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

    • Take care to place the screws in a safe place to prevent losing them.

  2. Protocol Galileo Stealth Light Emitting Diode (LED) Replacement: passo 2, immagine 1 di 1
    • Separate the upper and lower housing units by lightly pulling the two housing units apart.

  3. Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Light Emitting Diode (LED): passo 3, immagine 1 di 1
    • Remove 6mm Phillips #0 screw from the LED strip.

  4. Protocol Galileo Stealth Light Emitting Diode (LED) Replacement: passo 4, immagine 1 di 1
    • Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.

    • Take care not to damage the LED strip when removing it from the lower housing.

  5. Protocol Galileo Stealth Light Emitting Diode (LED) Replacement: passo 5, immagine 1 di 1
    • Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.

    • Avoid damaging the wire plug, wires, and motherboard when removing the wire plug.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

UW Stout, Team S8-G4, Ogden Spring 2018 Membro di UW Stout, Team S8-G4, Ogden Spring 2018

UWSTOUT-OGDEN-S18S8G4

4 Membri

6 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 137