Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grip the black plastic lever nub firmly and carefully remove it from the metal lever. Use one hand to hold the toaster in place while you pull the lever nub with the other.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flipping the toaster upside down, use a T7 Torx Screwdriver to remove the four 10mm screws that keep the outer shell attached.
-
Flip the toaster back over and slide off the shell making sure to slip the toaster lever (now without the black plastic nub) through the lever opening in the shell.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate and remove the two 8mm screws that attach the circuit board (located inside of the shell) from the shell itself using the Phillips #2 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate your damaged spring that holds the toaster lever in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the bottom part of the damaged spring from the lever first.
-
Then disconnect the top part of the damaged spring from the chassis.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Attach the new spring in the same spots that the damaged spring was removed from.
-