Salta al contenuto principale

Introduzione

Shows how to replace the entire power cord. This may need to be done if the device shut off mid-use. Be sure that the PopLite is unplugged from the wall and has had time after use to cool down before working on the device.

Ricambi

Nessuna parte specificata.

  1. Be sure that the popper is unplugged before disassembly.
    • Be sure that the popper is unplugged before disassembly.

    • Turn Presto Popper upside down.

  2. Remove the four 9 mm Phillips #2  screws from the base. Once all four screws are removed, take the base off. Once all four screws are removed, take the base off.
    • Remove the four 9 mm Phillips #2 screws from the base.

    • Once all four screws are removed, take the base off.

  3. Untwist the two orange twist-on wire connectors. Make a note of which wires are in each of the orange caps. Make a note of which wires are in each of the orange caps.
    • Untwist the two orange twist-on wire connectors.

    • Make a note of which wires are in each of the orange caps.

  4. Locate the plastic piece holding the power cord in place. Take the metal spudger from the tool kit and pry this piece loose. This plastic piece may take excessive force to pry out, just keep trying until it pops out.
    • Locate the plastic piece holding the power cord in place.

    • Take the metal spudger from the tool kit and pry this piece loose.

    • This plastic piece may take excessive force to pry out, just keep trying until it pops out.

    • Remove the power cord.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Emanuele Rocco

Membro da: 27/08/2015

694 Reputazione

6 Guide realizzate

Team

USF Tampa, Team 2-5, Blackwell Fall 2015 Membro di USF Tampa, Team 2-5, Blackwell Fall 2015

USFT-BLACKWELL-F15S2G5

2 Membri

6 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 319