Salta al contenuto principale

Introduzione

This guide shows how to replace the Presto PopLite 04820 Popping Chamber base. The Popping Chamber Base may need to be replaced if it has been coated with any popcorn residue that is permanent. Be sure that the PopLite is unplugged from the wall and has had time after use to cool down before working on the device.

Ricambi

Nessuna parte specificata.

  1. Be sure that the popper is unplugged before disassembly.
    • Be sure that the popper is unplugged before disassembly.

    • Turn Presto Popper upside down.

  2. Remove the four 9 mm Phillips #2  screws from the base. Once all four screws are removed, take the base off. Once all four screws are removed, take the base off.
    • Remove the four 9 mm Phillips #2 screws from the base.

    • Once all four screws are removed, take the base off.

  3. Remove the four 13 mm Phillips #2 screws. Remove the four 13 mm Phillips #2 screws.
    • Remove the four 13 mm Phillips #2 screws.

  4. Remove the entire cavity that holds the motor from the base of the PopLite.
    • Remove the entire cavity that holds the motor from the base of the PopLite.

    • Be gentle while taking the motor out of the base to avoid wire damage.

  5. Turn the popping chamber base sideways. Now remove popping chamber base.
    • Turn the popping chamber base sideways.

    • Now remove popping chamber base.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Emanuele Rocco

Membro da: 27/08/2015

694 Reputazione

6 Guide realizzate

Team

USF Tampa, Team 2-5, Blackwell Fall 2015 Membro di USF Tampa, Team 2-5, Blackwell Fall 2015

USFT-BLACKWELL-F15S2G5

2 Membri

6 Guide realizzate

Un commento

Where can I get the new base from?

Barry - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 7

Tutti i Tempi: 460