Introduzione
This is a prerequisite only.
Cosa ti serve
-
-
Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate.
-
Remove the back plate.
-
-
-
-
The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner.
-
Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.
-
Use tweezers or a plastic opening tool to disconnect the ribbon cable from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team 1-7, Leahy Fall 2015 Membro di USF Tampa, Team 1-7, Leahy Fall 2015
USFT-LEAHY-F15S1G7
3 Membri
5 Guide realizzate
