Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the G4 over.
-
Remove the eight T8 Torx screws from the lower case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your thumbs, slide the lower case away from you.
-
Lift the lower case off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Your laptop should look approximately like this.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Firmly grasp the plastic tab attached to the Airport card and pull up and to the left.
-
Disconnect the antenna cable from the left side of the Airport card.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the hard drive ribbon from the logic board using a spudger or the tip of your finger, removing tape as necessary.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To free the hard drive, remove the two T8 Torx screws from the right wall of the battery housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the hard drive by gently grasping the orange ribbon cable and lifting the left edge up and out of the computer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Your laptop should look approximately like this.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.