Introduzione

Replacing this keyboard is easy and takes only a few minutes.

Strumenti

Nessun attrezzo richiesto.

Remove both expansion bay modules using the levers on the front of the computer.
  • Remove both expansion bay modules using the levers on the front of the computer.

  • Insert your index fingers inside the expansion bays and search for the two ribbed tabs on the underside of the upper case. The tabs are located near the bottom corners of the keyboard.

  • Pull the tabs toward yourself and the keyboard will pop up.

Aggiungi Commento

Pull the keyboard forward to disengage the tabs holding it in back and rotate it toward you.
  • Pull the keyboard forward to disengage the tabs holding it in back and rotate it toward you.

  • Rest the keyboard on the trackpad.

Aggiungi Commento

  • This is a diagram of the ribbon clamp connectors you will disconnect in the next step.

  • 1) With your fingernails, grasp the locking bar on either side and pull up a small amount (about 1/16" or 2 mm).

  • 2) After disengaging the locking bar, slide the cable out of the connector.

Aggiungi Commento

  • Disconnect the two keyboard connectors by disengaging the clamps and pulling the ribbons directly upward.

Aggiungi Commento

  • Slide a spudger downward between each plastic strain relief cable and the wall of the case in order to bow out the cable beyond the small tab holding it in place.

  • Once the strain relief cables are free, lift the keyboard off.

Aggiungi Commento

  • Your laptop should look approximately like this.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

iRobot

Membro da: 24/09/2009

1 Reputazione

774 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 48

Tutti i Tempi: 16,640