Introduzione
How to remove and replace the PowerBook G3 Lombard Clutch Cover.
Cosa ti serve
-
-
Turn the computer so that the ports are facing you.
-
If the keyboard is locked, open the port cover and turn the keyboard locking screw until the keyboard is unlocked.
-
-
-
Remove the three silver Phillips screws that attach the heat shield to the internal metal framework.
-
-
-
-
Use a spudger, the tips of your fingers, or a flat non-metal tool to pry up the processor's right side.
-
-
-
Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.
-
Pull the RAM chip out.
-
-
-
Grasp the orange cable at the left end of the hard drive and disconnect it from the logic board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 37 persone hanno completato questa guida.