Annulla

Power Mac G5 Top Left Cooling Fan Unit Replacement

Scritto Da: Salvador Aguilar (e 7 altri collaboratori)

Commenti: 1
Preferiti: 7
Completamenti: 19

Power Mac G5 Top Left Cooling Fan Unit Replacement

Difficoltà

Facile

Passi

7

Tempo Necessario

5 - 10 minuti

Introduzione

These steps will show you how to install the top left cooling fan unit.

Strumenti

Nessun attrezzo specificato.

Parti

Nessuna parte specificata.

Passo 1 Side Panel

To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.

To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.
To avoid being burned, wait at least 10 minutes to allow the computer's internal components to cool.

Passo 2

Remove all the cables, including the power cables before opening the unit.

Remove all the cables, including the power cables before opening the unit.

Passo 3

Lift the tab to unlock the side panel.

The panel should fall out. If the panel does not fall out by itself pull a little from the edges.

Lift the tab to unlock the side panel.
The panel should fall out. If the panel does not fall out by itself pull a little from the edges.

Passo 4

Remove the air deflector (the clear plastic cover) by pulling on the handle.

Remove the air deflector (the clear plastic cover) by pulling on the handle.

Remove the air deflector (the clear plastic cover) by pulling on the handle.

Remove the air deflector (the clear plastic cover) by pulling on the handle.

Passo 5 Top Left Cooling Fan Unit

Locate the top left cooling fan unit.

Locate the top left cooling fan unit.

Passo 6

Pull the fan straight out from its slot. You will need to remove two cables from the motherboard.

Pull the fan straight out from its slot. You will need to remove two cables from the motherboard.
It may be easier to reach the cables if you remove the PCI guide (next to the fan unit) first.

Passo 7

After pulling out the fan unit, the area should look like this.

After pulling out the fan unit, the area should look like this.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 19 persone hanno completato questa guida.

Autore

con 7 altri collaboratori

Salvador Aguilar

Membro da: 21/01/2010

2.370 Reputazione

3 Guide realizzate

+9 altri distintivi

Team

Cal Poly, Team 5-8, Forte Winter 2010 Membro di Cal Poly, Team 5-8, Forte Winter 2010

CPSU-FORTE-W10S5G8

7 Membri

11 Guide realizzate

Un commento

Aggiungi un commento

Actually you do need to remove the plastic air deflector, as the fan in question is behind it.

Tim downing - 16/03/2016 Replica

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 41

Tutti i Tempi: 17,588