Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
If your Nerf Blaster latches and releases when you pull the trigger, but doesn't fire the dart, the O-ring might be ripped and need replacing. This guide will show you how to disassemble your Nite Finder so that you can replace the O-ring and the plunger.
==Caution==
Be aware of springs under compression. Take care so these small parts do not fly off the blaster and get lost.
Cosa ti serve
-
-
Place the blaster upside down on the table, and remove the screw in the bottom of the handle
-
Remove the battery door and take the batteries out.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.