Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect all cables. You have 4x Torx T8 screws and 7x Phillips screws. Now you can remove outer case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the power supply, first disconnect the two cables, then the 2 Phillips screws. Then lift it upwards.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Separate cables, unscrew the screw and remove the Blu Ray drive.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disassemble the upper metal shield by first unscrewing the 3 Phillips screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
For the 2-cables model, remove the two very small phillips screws in each lower corner referenced by the red circles.
-
For the 4-cables model, remove the small Phillips screw in the bottom left corner referenced by the red circle.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully remove the plastic shell, paying attention to the cable that runs through it for the 4-cables model.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4 Phillips screws at each corner of the laser mechanism.
-
Then remove the mechanism.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If necessary, transfer parts and screws from the old mechanism to the new one.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
You can test the console before full assembling.
-
To do this, reassemble the blu-ray drive, reconnect its cables, and reconnect the power supply.
-
Annulla: non ho completato questa guida.
Altre 16 persone hanno completato questa guida.
Un commento
Do you know what the part number is for the deck? I don’t want to buy the wrong one. Thanks.