Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Usa la punta di uno spudger per rimuovere dal lato della PS3 il coprivite in plastica nera.
-
-
-
Rimuovi le seguenti sette viti:
-
Sei viti Phillips da 52 mm
-
Una vite Phillips da 30 mm
-
-
-
-
Solleva la cover superiore dal suo bordo posteriore e ruotano verso la parte anteriore della PS3.
-
Rimuovi la cover superiore.
-
C'è un gancio in plastica posizionato in un foro sul retro dell'angolo superiore destro. Spingi con delicatezza con uno spudger il gancio in plastica verso la parte posteriore della console in modo da liberare la parte posteriore destra della console.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 9 mm Phillips screws securing the memory card reader to the chassis.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the memory card reader out of the PS3 enough to access its cable.
-
Flip up the retaining flap on the memory card reader ribbon cable socket.
-
Pull the ribbon cable out of its socket.
-
Remove the memory card reader from the PS3.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the DC-In cables toward the front of the PS3 to disconnect them from the power supply.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the AC-In cables slightly away from the rear cover for clearance to access the AC-In connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
While depressing its locking mechanism, pull the AC-In connector out of its socket on the power supply.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five 9 mm Phillips screws securing the power supply to the chassis.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the power supply upward from its front edge to disconnect it from the posts attached to the logic board.
-
Remove the power supply.
-
Annulla: non ho completato questa guida.
Altre 47 persone hanno completato questa guida.
6 Commenti
This is for the 60gb version. As there is no card reader in the 80gb i replaced the power supply in and some of the psu screws were in a slightly different place. But a very good guide.
I have a Ps3 that was bought in America. The power supply is different to ours here in South Africa (Cape Town). A friend who gave me the Ps3 also had an external power supply built so that it can be used here. It's been working for years but now I have that green light thingy going. I've removed the disc that was in it and thought it may have been inserted incorrectly. Now that I have seen your tutorial I will definitely check if it's the power supply or mother board. Thank you.
CAN I HAVE THE MANUAL MY RED LIGHT IS ON ALSO DIRECT ME TO A GOOD PLACE FOR REPAIRS IN ACCRA GHANA EMAIL honmante54@yahoo.com thank you
why do your consoles have this red light on why do something about it
I have a ps3 but it's the CECHL but it has no card