1. Remove screw covers, two are rubber feet, and the six screws located on the bottom of the console. Caution with the "Do not void" seal, underneath is also a screw Caution with the "Do not void" seal, underneath is also a screw
    • Remove screw covers, two are rubber feet, and the six screws located on the bottom of the console.

    • Caution with the "Do not void" seal, underneath is also a screw

  2. Spedizione gratuita per tutti gli ordini superiori a 100,00 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  3. If all screws are removed. Use a metal spunger to open the chassis
    • If all screws are removed.

    • Use a metal spunger to open the chassis

  4. Slip the three cables out of the sockets. Use a PH01 screwdriver to remove the four screws securing the optical drive Lift up the optical drive and remove the duct tape under the flex cable.
    • Slip the three cables out of the sockets.

    • Use a PH01 screwdriver to remove the four screws securing the optical drive

    • Lift up the optical drive and remove the duct tape under the flex cable.

    • Now the optical drive is free and ready for replacement

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 11 persone hanno completato questa guida.

tlroesner

Membro da: 13/05/2012

1.788 Reputazione

4 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 6

Ultimi 7 Giorni: 26

Ultimi 30 Giorni: 120

Tutti i Tempi: 15,581