Introduzione

This guide will show you how to locate and replace the fan in the PlayStation 2 Slimline.

Disconnect all cables from the console and flip the unit over to reveal its base.
  • Disconnect all cables from the console and flip the unit over to reveal its base.

Aggiungi Commento

Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.
  • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

  • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

Aggiungi Commento

  • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

Aggiungi Commento

  • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

  • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

Aggiungi Commento

  • Locate the fan at the front, left section of the unit.

Aggiungi Commento

  • Peel off the sticker holding the power cords to the unit.

Aggiungi Commento

  • Lift the connector from the motherboard with a pair of tweezers using a firm, upward force.

Aggiungi Commento

  • Remove all three 1.6 mm screws fastening the fan to the unit using a #1 Phillips screwdriver.

  • Gently lift and remove the fan from its compartment.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Thomas Sullivan

Membro da: 23/10/2013

2.211 Reputazione

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 51

Tutti i Tempi: 2,393