Introduzione

A faulty or defective front control panel may cause buttons on the media receiver to be unresponsive. Replacing the circuit board should resolve issues with the front controls and buttons.

Parti

Nessuna parte richiesta.

  1. Remove the two 6.4 mm Phillips screws on each side of the device's casing.
    • Remove the two 6.4 mm Phillips screws on each side of the device's casing.

    Aggiungi Commento

  2. Remove the two 6.5 mm Phillips screws on the back of the device casing.
    • Remove the two 6.5 mm Phillips screws on the back of the device casing.

    Aggiungi Commento

    • Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

    Aggiungi Commento

    • Unlatch the three plastic connectors on the top of the receiver that hold the front panel to the device casing.

    Aggiungi Commento

    • The connectors on the bottom of the device may be very stiff and could require the use of a plastic prying tool.

    • Carefully flip the device over and unlatch the three plastic connectors that hold the front panel to the bottom of the device casing.

    Aggiungi Commento

    • Grip and unplug the ribbon connector that connects the front circuit board to the device.

    Aggiungi Commento

    • Unscrew the three 1/4 Phillips head screws on the back of the front circuit board.

    Aggiungi Commento

    • Grip the circuit board and slide towards the front side of the plastic casing.

    • Lift upwards to remove the circuit board from the front panel.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Cody Carter

Membro da: 30/01/2018

1.049 Reputazione

6 Guide realizzate

Team

Baylor, Team S1-G5, Johnson Spring 2018 Membro di Baylor, Team S1-G5, Johnson Spring 2018

BU-JOHNSON-S18S1G5

3 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 77