Introduzione

This guide is for the Philips Sonicare 2 series HX6211/46 toothbrush. It shows you how to replace the motor for this toothbrush. He is a link for a guide how to soldering which will be needed for this guide. Come saldare e dissaldare connessioni elettriche

  1. Remove brush on top of device.
    • Remove brush on top of device.

  2. Remove the 12 mm T8 Torx screw from the bottom of the toothbrush. After removing the screw, pry off the base with a plastic opening tool.
    • Remove the 12 mm T8 Torx screw from the bottom of the toothbrush. After removing the screw, pry off the base with a plastic opening tool.

  3. Remove the internal electronic mechanism from the housing by prying the red clips shown in the figure. This removes the charging port. Be very careful not to damage the charging port during this step.  Otherwise you will have to solder this part back to the device as shown in the second figure.
    • Remove the internal electronic mechanism from the housing by prying the red clips shown in the figure. This removes the charging port.

    • Be very careful not to damage the charging port during this step. Otherwise you will have to solder this part back to the device as shown in the second figure.

  4. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  5. Next you will be able to remove the internal electronic mechanism as shown in the figure.
    • Next you will be able to remove the internal electronic mechanism as shown in the figure.

  6. Remove the white battery cover as shown in the figure.
    • Remove the white battery cover as shown in the figure.

  7. Remove the white circuit board cover as shown. This cover will require you to pry off the piece from the groves .
    • Remove the white circuit board cover as shown. This cover will require you to pry off the piece from the groves .

  8. Disassemble the device. Remove the plastic piece over the brush attachment as shown. Object can be removed by hand as shown. No tool is required.
    • Disassemble the device. Remove the plastic piece over the brush attachment as shown. Object can be removed by hand as shown. No tool is required.

  9. Desolder the motor from the circuit board at the two locations shown.
    • Desolder the motor from the circuit board at the two locations shown.

  10. Remove the bad motor.
    • Remove the bad motor.

Linea Traguardo

Jonathan Jarvis

Membro da: 01/04/2016

452 Reputazione

4 Guide realizzate

Team

IUPUI, Team S6-G2, Baechle Fall 2017 Membro di IUPUI, Team S6-G2, Baechle Fall 2017

IUPUI-BAECHLE-F17S6G2

3 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 40

Tutti i Tempi: 541