Skip to main content

Introduzione

Use this guide to replace the battery of your Philips Norelco 2100 as it may be defective.

  1. Remove the single screw on the back casing using a T8 Torx screwdriver.
    • Remove the single screw on the back casing using a T8 Torx screwdriver.

  2. Turn the shaver so that it is facing you. Press the button on the shaver head to open it.
    • Turn the shaver so that it is facing you.

    • Press the button on the shaver head to open it.

  3. Remove the two 10.1 mm screws inside the shaver head using a T8 Torx screwdriver.
    • Remove the two 10.1 mm screws inside the shaver head using a T8 Torx screwdriver.

  4. Kit di riparazione per Android

    Un nuovo schermo o una nuova batteria sono ad un kit di distanza.

    Acquista ora

    Kit di riparazione per Android

    Un nuovo schermo o una nuova batteria sono ad un kit di distanza.

    Acquista ora
  5. Lift the shaver head off of the casing. Lift the shaver head off of the casing.
    • Lift the shaver head off of the casing.

  6. Gently pull the black and blue casing apart using a metal spudger. Gently pull the black and blue casing apart using a metal spudger. Gently pull the black and blue casing apart using a metal spudger.
    • Gently pull the black and blue casing apart using a metal spudger.

  7. Pry the remaining casing open using a metal spudger. Be careful using a metal spudger, as it may result in damaging the case. Be careful using a metal spudger, as it may result in damaging the case.
    • Pry the remaining casing open using a metal spudger.

    • Be careful using a metal spudger, as it may result in damaging the case.

  8. Remove the clear case that holds the circuit board by lifting the latches on the sides and then pulling gently. Remove the clear case that holds the circuit board by lifting the latches on the sides and then pulling gently. Remove the clear case that holds the circuit board by lifting the latches on the sides and then pulling gently.
    • Remove the clear case that holds the circuit board by lifting the latches on the sides and then pulling gently.

  9. Located directly behind the circuit board, remove the battery from the device.
    • Located directly behind the circuit board, remove the battery from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Team

USF Tampa, Team S1-G4, Thompson Fall 2017 Membro di USF Tampa, Team S1-G4, Thompson Fall 2017

USFT-THOMPSON-F17S1G4

3 Membri

5 Guide realizzate

To remove the battery you have to actually desolder both ends from the chip.

AGUSTIN CABRA - Replica

What are the dimensions/specs of the battery?

Haley Pearse - Replica

regular AA rechargeable batteries will not work and can be a fire hazard.

steven - Replica

The tricky part is taking the case appart. You have to gently pry on tabs to get it appart. You may break some pieces which probably won’t be a problem. May make it no longer waterproof. The battery is custom but is close to a 14450 Lion battery, do searches on ebay and aliexpress you will find them. Good luck.

Don - Replica

Add Comment

View Statistics:

Past 24 Hours: 12

Past 7 Days: 84

Past 30 Days: 324

All Time: 3,633