Philips BiPAP S/T Humidifier Replacement

Introduzione

A unique aspect of this BiPAP device is its attached built-in humidifier. However, when this feature isn’t working properly, the device is ineffective and your comfort can significantly decline.

The humidifier feature should be checked every few months to ensure that it is working properly. The following guide details how to take all of these parts apart and replace them if they are malfunctioning.

For more information on replacing the humidifier, please refer to page 7-2 in the service manual.

Cosa ti serve

Passo 1 Humidifier

Philips BiPAP S/T Humidifier Replacement, Humidifier: passo 1, immagine 1 di 1

Remove the Water Chamber Assembly.
Gently squeeze the latch on the Flip Lid Assembly to release it.
Lift the Flip Lid Assembly.
Pull the Humidifier Tank Assembly out of the Humidifier.

Traduci

Passo 2

Remove the Tank Top Seal from the Flip Lid Assembly.
If this is the source of the error, put in a new one.

Traduci

Passo 3

Remove the Dry Box Seal.
If this is the source of error, place this part with a new one.
When replacing, ensure that the narrow end of the seal is inserted into the Dry Box.

Traduci

Passo 4

Remove the Dry Box Assembly.
Insert a flat blade screwdriver into the hole located on the back of the Humidifier and lightly press inward to release the Dry Box Assembly.
Do not press firmly on the screwdriver as damage may occur.
Remove the Inlet Seal from the Dry Box Assembly

Traduci

Passo 5

Philips BiPAP S/T Humidifier Replacement: passo 5, immagine 3 di 3

Remove the Flip Lid Assembly.
Use a screwdriver to push in on the latches that secure the Flip Lid Assembly to the Humidifier Top Housing.
Bend the Flip Lid Assembly completely backwards until it is removed.
For Heated Tube devices, remove the wire harness from the base.

Traduci

Passo 6

Use a T8 Torx screwdriver to remove the four #4 x 1/2" screws that secure the Top Housing to the Humidifier Bottom Housing

Traduci

Passo 7

Slide the Outside Cover out of the Bottom Housing.

Traduci

Passo 8

Remove the Left Side Panel.
Use a T15 Torx screwdriver to remove the four #6 x 1/4" screws that secure the Bottom Housing to the Lower Base Assembly.

Traduci

Passo 9

Remove the Heater Plate Assembly.
The Heater Plate Assembly is secured by two small tabs.
Once replaced, secure the Bottom Housing to the Lower Base using the four #6 x 1/4" screws.
Be sure the Heater Plate Spring is properly seated under the Heater Plate.