Petmate 29027 Fountain Lid and Pump Replacement

Introduzione

Use this guide to replace a pump on your Petmate 29027 pet flower fountain. The water pump fits a pet water fountain and produces water movement. It made up of the impeller, stator, and intake plate. If the fountain feels slimy, leaking, too loud noise, or stopped working, it may need to be replaced by the pump.

Sometimes, you may only need to clean the pump rather than replace it. If cleaning does not work, please carefully follow the operating instructions to replace the pump. Before replacing the pump, make sure to power off your pet fountain completely and disconnect from any external power source. After replacement, please test the fountain and ensure the pump works well.

Cosa ti serve

Passo 1 Fountain Lid and Pump

Petmate 29027 Fountain Lid and Pump Replacement, Fountain Lid and Pump: passo 1, immagine 1 di 3

Petmate 29027 Fountain Lid and Pump Replacement, Fountain Lid and Pump: passo 1, immagine 2 di 3

Petmate 29027 Fountain Lid and Pump Replacement, Fountain Lid and Pump: passo 1, immagine 3 di 3

Unplug the fountain from the electrical source and disconnect the inline plug.
Remove the lid.
Empty water from the fountain
Reach in the bowl and lift up the pump.

Modifica

Passo 2

Petmate 29027 Fountain Lid and Pump Replacement: passo 2, immagine 3 di 3

Unclip the lid and intake plate using a fingernail.

Modifica

Passo 3

Pry out the impeller (4 white bladed propellers) which is held in place magnetically.
You can use a fingernail or small needle nose pliers to get under the plastic blade and lift it out.

Modifica

Passo 4

Petmate 29027 Fountain Lid and Pump Replacement: passo 4, immagine 3 di 3

Clean the parts with warm soapy water and reassemble them.
Be sure to rinse thoroughly with fresh water.
Cleaning the motor with white vinegar (150ml) can increase disinfecting and hard water removal.