Strumenti

Parti

Nessuna parte richiesta.

  1. Turn over the Delphi MyFi XM2GO Device on its back to start the cover-removal process.
    • Turn over the Delphi MyFi XM2GO Device on its back to start the cover-removal process.

    Aggiungi Commento

  2. Locate the large button on the top back of the device.
    • Locate the large button on the top back of the device.

    • Press this button at the top while making a firm grip on the battery cover.

    • As the button is pressed, move the cover towards the bottom of the device.

    • The battery removal tab may pop up during the cover removal process.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Holding the device, grab the tab with thumb and index figure.

    • Pull down on the tab to move the battery block a few millimeters towards the bottom of the device to unlock the latch at the top.

    • After the latch at the top is disengaged, pivot the battery away from the back and the battery will be free.

    Aggiungi Commento

    • After removing the battery cover and battery, locate the reset (indicated by arrow).

    Aggiungi Commento

    • Unbend the paper clip, making it straight. CAUTION: The ends may be sharp.

    • Carefully insert one end of the paper clip into the hole to reset the device.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aubrey

Membro da: 09/03/2012

54 Reputazione

3 Guide realizzate

Team

Clemson, Team 1-2, Benson Spring 2012 Membro di Clemson, Team 1-2, Benson Spring 2012

CLEM-BENSON-S12S1G2

3 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 31

Tutti i Tempi: 5,141