Salta al contenuto principale

Pentax Optio WG-2 Back Case Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Cosa ti serve

  1. Pentax Optio WG-2 Back Case Replacement, Back Case: passo 1, immagine 1 di 2 Pentax Optio WG-2 Back Case Replacement, Back Case: passo 1, immagine 2 di 2
    • Remove all four 1 mm JIS #00 screws from the back of the camera.

  2. Pentax Optio WG-2 Back Case Replacement: passo 2, immagine 1 di 1
    • Use your finger to peel the grip off the top of the camera.

    • For best results, start from the right side of the camera, opposite the buttons.

    • Once the grip is removed, you will most likely lose the water-tight seal.

  3. Pentax Optio WG-2 Back Case Replacement: passo 3, immagine 1 di 1
    • Use the tweezers to remove the two buttons from the top of the camera.

    • The buttons may fall out while removing the grip.

  4. Pentax Optio WG-2 Back Case Replacement: passo 4, immagine 1 di 3 Pentax Optio WG-2 Back Case Replacement: passo 4, immagine 2 di 3 Pentax Optio WG-2 Back Case Replacement: passo 4, immagine 3 di 3
    • Remove the three 1 mm JIS #000 screws from the top.

    • Remove the 1 mm JIS #000 screw from the bottom.

  5. Pentax Optio WG-2 Back Case Replacement: passo 5, immagine 1 di 1
    • Carefully separate the back and the front of the camera.

    • There are three ribbon cables connecting the two boards. Be careful not to tear them.

  6. Pentax Optio WG-2 Back Case Replacement: passo 6, immagine 1 di 1
    • Use the tip of a spudger to flip up the small retaining flaps on the ribbon cable ZIF connectors.

    • Carefully pull the ribbon cables out of their sockets.

Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 2

Tutti i Tempi: 142