Introduzione

This guide will take you through the steps of removing the touchscreen.

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

Aggiungi Commento

Slide the latch to the right and then down to unlock it.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

Aggiungi Commento

  • Remove the four hinge screws from the back of the computer.

Aggiungi Commento

  • Open the laptop and remove the four indicated screws with a Phillips size 0 screwdriver.

  • Pry off the plastic strip which was previously held in place by the screws.

Aggiungi Commento

  • Remove the four hinge screws to allow the hinges to rotate up and move.

Aggiungi Commento

  • Remove 16 screws from the top of the closed laptop.

    • 12 Phillips size 1 screws

    • 2 Phillips size 0 screws

    • 2 Torx size 6 screws (T6)

I found that the Torx screw on my model to be T8.

Harley - Replica

Is the touchscreen & the LCD 1 piece? or are they separate?

Chasity Miller -

  • Gently break the adhesive seal between the front and rear display cases with a plastic opening tool.

    • You will need to reapply the silicon adhesive during reassembly to ensure watertight seal.

Aggiungi Commento

  • Pull the top halve of the casing up revealing the inside of the screen

Aggiungi Commento

  • The top half of the case can be removed by sliding the tabs out from under the hinges.

    • This makes unplugging the screen wiring much easier

Aggiungi Commento

  • There are 4 wires that need to be unplugged to remove the screen.

Aggiungi Commento

  • For the first wire, peel back the silver cover tape to reveal the connection.

Aggiungi Commento

  • Pull the wiring away from the connection to release it.

Aggiungi Commento

  • Remove the 3 strips of black tape as shown to reveal connections 2 and 3.

  • Pull the wiring for each away from the connections to remove.

Aggiungi Commento

  • The 4th connection is already visible.

    • Depending on your model it might not be plugged into anything. If it is, remove it the same way the other 3 connections were removed.

Aggiungi Commento

  • Using a plastic opening tool, lift the screen as shown from the case and pull free.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Dylan Bloom

Membro da: 12/04/2010

262 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 27-93, Amido Spring 2010 Membro di Cal Poly, Team 27-93, Amido Spring 2010

CPSU-AMIDO-S10S27G93

4 Membri

12 Guide realizzate

This guide is good for replacing the LCD screen, but it is not complete for the touchscreen panel, which requires some more delicate and precise steps. I think the title of the guide needs to be changed.

Thanks

Alessandro Cervelli - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 30

Tutti i Tempi: 15,259