Introduzione

Taking the power board out of the chassis

Parti

Nessuna parte richiesta.

  1. Eject the disk tray from the DVD player before removing power supply.
    • Eject the disk tray from the DVD player before removing power supply.

  2. Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.
    • Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.

  3. Remove 3 screws running along back edge of case cover. Remove 2 screws from each side of case cover.
    • Remove 3 screws running along back edge of case cover.

    • Remove 2 screws from each side of case cover.

  4. Spedizione gratuita per tutti gli ordini superiori a 100,00 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio

    Mai riparato qualcosa? Questo è Genio.

    Condividi la tua storia di riparazione con #ImAGenius

    Siamo tutti Geni

    Condividi la tua storia di riparazione con #ImAGenius

  5. Grab edges of cover, pull outward slightly, and pull straight up.
    • Grab edges of cover, pull outward slightly, and pull straight up.

  6. Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player. Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.
    • Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.

  7. Locate the 4 screws securing the disk drive assembly. There are two on each side. Use a narrow screwdriver to remove all 4 screws. Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector.
    • Locate the 4 screws securing the disk drive assembly. There are two on each side.

    • Use a narrow screwdriver to remove all 4 screws.

    • Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector.

  8. Lift assembly by the front to pull metal bracket from the power board.
    • Lift assembly by the front to pull metal bracket from the power board.

    • Pull up back end and lift drive out.

  9. With the drive assembly separate from the player, hold as shown and pull the bracket edges away from the disk drive.
    • With the drive assembly separate from the player, hold as shown and pull the bracket edges away from the disk drive.

    • Lift bracket off and reserve for re-assembly.

  10. Remove 4 screws from the power board as shown. Lift the power board straight up and out of the chassis.
    • Remove 4 screws from the power board as shown.

    • Lift the power board straight up and out of the chassis.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Kevin

Membro da: 26/04/2011

351 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 18-20, Garner Spring 2011 Membro di Cal Poly, Team 18-20, Garner Spring 2011

CPSU-GARNER-S11S18G20

4 Membri

11 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 23

Tutti i Tempi: 3,993