Aggiusta la tua roba Comunità Store

Panasonic Lumix DMC-ZS3 Back Cover Replacement

Introduzione

Use this guide to replace the back cover of your Panasonic Lumix DMC-ZS3 camera, which houses the back panel buttons and LCD screen.

Cosa ti serve

  1. Panasonic Lumix DMC-ZS3 Back Cover Replacement, Back Cover: passo 1, immagine 1 di 3 Panasonic Lumix DMC-ZS3 Back Cover Replacement, Back Cover: passo 1, immagine 2 di 3 Panasonic Lumix DMC-ZS3 Back Cover Replacement, Back Cover: passo 1, immagine 3 di 3

    • Remove the following eleven screws securing the covers to the ZS3

    • Eleven 3 mm Phillips screws

    • Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.

    Traduci

  2. Panasonic Lumix DMC-ZS3 Back Cover Replacement: passo 2, immagine 1 di 2 Panasonic Lumix DMC-ZS3 Back Cover Replacement: passo 2, immagine 2 di 2

    • Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown.

    • Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.

    Traduci

  3. Panasonic Lumix DMC-ZS3 Back Cover Replacement: passo 3, immagine 1 di 2 Panasonic Lumix DMC-ZS3 Back Cover Replacement: passo 3, immagine 2 di 2

    • Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit.

    • Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

    Traduci

  4. Panasonic Lumix DMC-ZS3 Back Cover Replacement: passo 4, immagine 1 di 1

    • Remove the two LCD board ribbon cables out of their sockets.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 8

Tutti i Tempi: 770