Introduzione

This guide will take you through the steps of how to replace the flash assembly.

Parti

Nessuna parte richiesta.

  1. Move the switch on the battery door to the Open position.
    • Move the switch on the battery door to the Open position.

    • The door will automatically swing open after you let it go.

    Aggiungi Commento

  2. Push the small gray tab on the top right corner to the left. The battery will pop out slightly.
    • Push the small gray tab on the top right corner to the left. The battery will pop out slightly.

    • Keep your finger clear of the battery when it pops out.

    Aggiungi Commento

    • Push the memory card in and let go.

    • The memory card will pop out slightly.

    • Pull out the memory card.

    Aggiungi Commento

    • Unscrew the small screws on the sides of the camera.

    • The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).

    Aggiungi Commento

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unscrew the three small screws on the bottom(#00P, 3.3mm).

    • The bottom will fall off.

    Aggiungi Commento

    • Lift up the bottom back cover by prying the bottom edge with the spudger.

    • Gently lift up the back cover with your hand from the bottom to the top.

    Aggiungi Commento

    • Lift the tabs on the ZIF connectors.

    • The ribbon cables should easily come out of the ZIF connectors.

    Aggiungi Commento

    • Using the spudger, pry off the top cover by gliding the spudger along the entire edge between the top cover and the front cover.

    • Be careful not to damage the cylindrical capacitor on the circuit board under the top cover.

    Aggiungi Commento

    • Unscrew the small screws beneath the top cover(#00P, 1.7mm).

    Aggiungi Commento

    • Lift the logic board out with your hand by pushing the tabs out and pulling the logic board up.

    • The on/off switch and the anti-shake button may fall out.

    Aggiungi Commento

    • The flash assembly is hardwired into the top circuit board.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Karissa

Membro da: 13/04/2012

50 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 6-23, Amido Spring 2012 Membro di Cal Poly, Team 6-23, Amido Spring 2012

CPSU-AMIDO-S12S6G23

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 363