Introduzione

This guide will show you how to remove the back panel of your camera.

Parti

Nessuna parte richiesta.

Move the switch on the battery door to the Open position.
  • Move the switch on the battery door to the Open position.

  • The door will automatically swing open after you let it go.

Aggiungi Commento

Push the small gray tab on the top right corner to the left. The battery will pop out slightly.
  • Push the small gray tab on the top right corner to the left. The battery will pop out slightly.

  • Keep your finger clear of the battery when it pops out.

Aggiungi Commento

  • Push the memory card in and let go.

  • The memory card will pop out slightly.

  • Pull out the memory card.

Aggiungi Commento

  • Unscrew the small screws on the sides of the camera.

  • The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).

Aggiungi Commento

  • Unscrew the three small screws on the bottom(#00P, 3.3mm).

  • The bottom will fall off.

Aggiungi Commento

  • Lift up the bottom back cover by prying the bottom edge with the spudger.

  • Gently lift up the back cover with your hand from the bottom to the top.

Aggiungi Commento

  • Lift the tabs on the ZIF connectors.

  • The ribbon cables should easily come out of the ZIF connectors.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Karissa

Membro da: 13/04/2012

50 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 6-23, Amido Spring 2012 Membro di Cal Poly, Team 6-23, Amido Spring 2012

CPSU-AMIDO-S12S6G23

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 9

Tutti i Tempi: 1,053