Introduzione

This guide will show the user how to disassemble the camera to reach the Flash Top Assembly. Once the Flash Top Assembly is reached, the user can replace it.

Parti

Nessuna parte richiesta.

Locate the memory card and battery card latch on the bottom of the camera.
  • Locate the memory card and battery card latch on the bottom of the camera.

  • Slide the latch to the open position.

Aggiungi Commento

Open the battery latch, and slide the battery release lever to the right.
  • Open the battery latch, and slide the battery release lever to the right.

Aggiungi Commento

  • Remove the battery from the camera.

Aggiungi Commento

  • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

  • Use this screwdriver for all screws in the device.

Aggiungi Commento

  • Remove the 3.15 mm screw on the left side of the camera.

Aggiungi Commento

  • Remove the left side casing.

Aggiungi Commento

  • Remove the two 3.15 mm screws on the right side of the camera.

Aggiungi Commento

  • Remove the bottom right panel.

Aggiungi Commento

  • Gently remove the back casing.

  • Start at the bottom and carefully pry towards the top to get this piece free.

Aggiungi Commento

  • Carefully pry the Flash Top Assembly away from the top.

Aggiungi Commento

  • Replace the Flash Top Assembly with a new one.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Caleb Fink

Membro da: 11/10/2010

186 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 9-22, Regan Fall 2010 Membro di Cal Poly, Team 9-22, Regan Fall 2010

CPSU-REGAN-F10S9G22

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 3,517