Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the lock switch to the right so that it is in the unlocked position.
-
Use your finger to slide the battery hatch in the direction of the downward arrow so that the hatch is open.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open the battery hatch and then the black cover to expose the battery compartment.
-
Remove the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Phillips #00 screwdriver, remove the two 2.8 mm screws located under the hatch.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 screwdriver to remove the three 2.8 mm screws on the bottom of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 screwdriver to remove the two 2.8 mm screws on the side of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to pry open the case at all sides.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use your fingers to carefully remove the back casing from the front of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the camera on a flat surface with the front side facing down.
-
Use the spudger to flip up the retaining flap and slide the ribbon cable out of the connector.
-
Hold down on the camera's metal casing with one hand. Using your other hand, remove the back case from the rest of the camera.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.