Introduzione

Be sure to remove the battery and SD card before opening the camera to get to the screen component.

Parti

Nessuna parte richiesta.

Open and rotate the screen, then remove the screw(3.5mm Philips) indicated with a screwdriver.
  • Open and rotate the screen, then remove the screw(3.5mm Philips) indicated with a screwdriver.

  • Then, rotate the screen 180 degrees and remove the screw on the opposite side.

Aggiungi Commento

Remove the screw(2.6mm Philips) indicated on the top of the screen with the screwdriver. Then remove the corresponding screw on the bottom of the screen.
  • Remove the screw(2.6mm Philips) indicated on the top of the screen with the screwdriver. Then remove the corresponding screw on the bottom of the screen.

Aggiungi Commento

  • Pull the backing away from the screen as shown in the photo.

Aggiungi Commento

  • Unplug the black connector between the camera and the screen by pulling down.

  • For increased ease, use tweezers or forceps, as seen in the picture

Aggiungi Commento

  • Pull the screen away from the camera the same way that you removed the screen backing.

Aggiungi Commento

  • Use the screwdriver to remove the screw(2.46mm Philips) indicated.

Aggiungi Commento

  • Pull upwards on the screen border to remove it from the actual screen.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Zoe Hinck

Membro da: 12/04/2012

29 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 6-19, Amido Spring 2012 Membro di Cal Poly, Team 6-19, Amido Spring 2012

CPSU-AMIDO-S12S6G19

3 Membri

6 Guide realizzate

I need the LCD screen, can you helpme?

leon - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 5

Tutti i Tempi: 731