Introduzione

Make sure you have a replacement board before starting. Refer to the these sites for replacement parts. http://www.palmmediccanada.com/pm1xx.htm or http://www.directfix.com/category/_PM1.h...

Parti

Nessuna parte richiesta.

  1. Start with your intact Palm m105.
    • Start with your intact Palm m105.

    Aggiungi Commento

  2. Remove protective flap by pulling directly out from the top.
    • Remove protective flap by pulling directly out from the top.

    • The two clips will pop out

    Aggiungi Commento

    • Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.

    • The Faceplate will then easily lift off

    Aggiungi Commento

    • Using a T5 Torx bit screwdriver, remove the four screws located on the back of the device turning counter clockwise.

    • The link to purchase this screwdriver is Located here.

    Aggiungi Commento

    • This is what the device looks like once you have taken the screws out and opened the device.

    Aggiungi Commento

    • The Motherboard and screen will pop out of the back case easily.

      • Be careful when doing this step, the components are fragile.

    Aggiungi Commento

    • To remove the screen from the motherboard there are going to be three tabs that need to pulled up.

    • ** This step needs to be done with special care because it is very fragile.**

    • Once they are all three popped up the motherboard and screen will separate easily.

    Aggiungi Commento

  3. Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aaron

Membro da: 04/10/2011

7 Reputazione

1 Guida realizzata

Team

UW Stout, Team 1-3, Zhou Fall 2011 Membro di UW Stout, Team 1-3, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G3

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 785