Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Begin with the Palm m105 facing you on a flat surface.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the protective screen cover by flipping it up and pulling it directly away from the top of the device.
-
The two clips located on the protective screen should pop out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the faceplate, lift the tab located at the top of the device.
-
The faceplate should easily lift off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a T-5 Torx screwdriver, remove all four screws located on the back of the device. Turn counterclockwise to remove screws. The link to purchase this screwdriver is located at the top of this page.
-
Once you have removed all four screws, the device will be in three separate pieces (the back, the computer, and the button board).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After step four, locate the button board. The button board should have a frame attached to it. Remove this frame.
-
To remove the buttons from the frame, apply even pressure on two buttons at a time. This should make them pop out easily. Once you have removed the buttons, you can now wash or replace them.
-
To insert a new set of buttons, push it back into the opening on the faceplate, and you should feel it click into place.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.