Aggiusta la tua roba Comunità Store

Palm m 100 Cover Replacement

Introduzione

If the front and/or rear cover is cracked, this guide will teach the user to remove the damaged cover and replace with a new one.

Cosa ti serve

  1. Palm m 100 Cover Replacement, Cover: passo 1, immagine 1 di 1

    • Remove the batteries.

    Modifica

  2. Palm m 100 Cover Replacement: passo 2, immagine 1 di 1

    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

    Modifica

  4. Palm m 100 Cover Replacement: passo 3, immagine 1 di 3 Palm m 100 Cover Replacement: passo 3, immagine 2 di 3 Palm m 100 Cover Replacement: passo 3, immagine 3 di 3

    • Remove rear cover by gently lifting it up from the bottom. To remove the front cover, flip the device over, and then separate the screen/circuit board from the cover.

    Modifica

  5. Palm m 100 Cover Replacement: passo 4, immagine 1 di 1

    • Set aside broken cover, and replace with a new cover.

    Modifica

  6. Palm m 100 Cover Replacement: passo 5, immagine 1 di 1

    • Close again like a book, and lay it gently into the front panel. Make sure the screen is facing outwards of the front panel.

    Modifica

  7. Palm m 100 Cover Replacement: passo 6, immagine 1 di 1

    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Anne Carey

Membro da: 10/25/11

1 Reputazione

3 Guide realizzate

Distintivi: 1

Team

James Madison, Team 1-3, Allen Fall 2011 Membro di James Madison, Team 1-3, Allen Fall 2011

JMU-ALLEN-F11S1G3

5 Membri

5 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 537