Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Palm Treo 650 Motherboard Replacement

Cosa ti serve

  1. Palm Treo 650 Motherboard Replacement, Battery and Stylus: passo 1, immagine 1 di 1
    • Position the phone so the screen faces down.

    • Remove the stylus found on the back of the phone.

  2. Palm Treo 650 Motherboard Replacement: passo 2, immagine 1 di 1
    • Hold the button in the middle of the phone's back to remove the battery cover.

    • Slide the cover down to remove it, and set the cover aside.

  3. Palm Treo 650 Motherboard Replacement: passo 3, immagine 1 di 2 Palm Treo 650 Motherboard Replacement: passo 3, immagine 2 di 2
    • Lift the edge of the battery, separating contact points, and pull out as pictured.

  4. Palm Treo 650 Motherboard Replacement, Case: passo 4, immagine 1 di 1
    • Remove the round, rubber cover to expose a screw that will be removed in the next step.

  5. Palm Treo 650 Motherboard Replacement: passo 5, immagine 1 di 2 Palm Treo 650 Motherboard Replacement: passo 5, immagine 2 di 2
    • Remove the six 6.9 mm screws as pictured with a T5 Torx screwdriver.

    • Remove the single 9.8 mm screw next to the antenna on the back plate, using a Phillips #00 screwdriver.

  6. Palm Treo 650 Motherboard Replacement: passo 6, immagine 1 di 1
    • Pull the antenna outward to remove the antenna from the body of the phone.

  7. Palm Treo 650 Motherboard Replacement: passo 7, immagine 1 di 2 Palm Treo 650 Motherboard Replacement: passo 7, immagine 2 di 2
    • Pry the back cover off using an iFixit opening tool.

    • Several small clips on the inside attach to the back cover.

  8. Palm Treo 650 Motherboard Replacement, Motherboard: passo 8, immagine 1 di 3 Palm Treo 650 Motherboard Replacement, Motherboard: passo 8, immagine 2 di 3 Palm Treo 650 Motherboard Replacement, Motherboard: passo 8, immagine 3 di 3
    • Unclip the gray tab.

    • Pull out the orange ribbon cable.

    • Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!

  9. Palm Treo 650 Motherboard Replacement: passo 9, immagine 1 di 2 Palm Treo 650 Motherboard Replacement: passo 9, immagine 2 di 2
    • Pull off the mother board.

    • Install replacement or repaired motherboard, reversing steps above.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

mmedrano

Membro da: 11/15/09

95 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 19-3, Maness Fall 2009 Membro di Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Membri

18 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 4,254