Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

How to access the motherboard for repair.

  1. Position the phone so the screen faces down.
    • Position the phone so the screen faces down.

    • Remove the stylus found on the back of the phone.

  2. To remove the battery cover, hold down the button in the middle of the phone's back.
    • To remove the battery cover, hold down the button in the middle of the phone's back.

    • Slide the cover down to remove. Set the cover aside.

  3. Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
    • Lift the edge of the battery, separating contact points, and pull out as pictured.

  4. Remove the small round rubber cover on the back of the phone located immediately below the antenna.
    • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

    • This will uncover a screw that will be removed in the next step.

  5. Unscrew the screws around the back plate with a T5 Torx Screwdriver. Six black 6.9 mm Torx screws
    • Unscrew the screws around the back plate with a T5 Torx Screwdriver.

    • Six black 6.9 mm Torx screws

    • Unscrew the screw next to the antennae on the back plate.

    • One 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  6. Remove the antennae.
    • Remove the antennae.

  7. Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
    • Pry the back cover off using a spudger or similar tool.

    • The back cover is attached by several small clips on the inside.

  8. Disconnect the ribbon cable before removing the motherboard. Unclip the gray tab. Pull out the orange ribbon cable.
    • Disconnect the ribbon cable before removing the motherboard.

    • Unclip the gray tab.

    • Pull out the orange ribbon cable.

  9. Pull off the mother board. Install replacement or repaired motherboard, reversing steps above.
    • Pull off the mother board.

    • Install replacement or repaired motherboard, reversing steps above.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

mmedrano

Membro da: 15/11/2009

95 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 19-3, Maness Fall 2009 Membro di Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Membri

18 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 4,098