Introduzione

How to access the motherboard for repair.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

Aggiungi Commento

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

Aggiungi Commento

  • Lift the edge of the battery, separating contact points, and pull out as pictured.

Aggiungi Commento

  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

Aggiungi Commento

  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

Aggiungi Commento

  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

Aggiungi Commento

  • Unclip the gray tab.

  • Pull out the orange ribbon cable.

  • Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!

Aggiungi Commento

  • Pull off the mother board.

  • Install replacement or repaired motherboard, reversing steps above.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

mmedrano

Membro da: 15/11/2009

67 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 19-3, Maness Fall 2009 Membro di Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Membri

18 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 4,003