Parti

Nessuna parte richiesta.

  1. Make sure your Palm Pre is turned off before disassembling the phone.
    • Make sure your Palm Pre is turned off before disassembling the phone.

    • Snap off the back panel to reveal the battery.

    Aggiungi Commento

  2. Carefully pull up on the tab to remove the current battery.
    • Carefully pull up on the tab to remove the current battery.

    Aggiungi Commento

    • Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.

    Aggiungi Commento

    • Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)

    • Use a spudger to pry open the hinge.

    • Use tweezers to disconnect the antennas from the keypad control board.

    Aggiungi Commento

    • Use a spudger to pry off the (black and yellow) back frame.

      • Disregard the main part of the phone at this point and look only at the inside of the removed back frame. (You will need the main part of the phone for access to the keyboard and motherboard)

    Aggiungi Commento

    • Find the small circuit board at the top right and desolder the wires that are connected to it.

      • This step is only necessary for antenna removal.

    Aggiungi Commento

    • Remove the two ribbon cable connectors using tweezers.

    Aggiungi Commento

    • Use a spudger to remove the keypad control board.

      • There is heavy adhesive connecting this part to the keypad sensors.

    Aggiungi Commento

    • Slide the keyboard away from the phone.

    • Use tweezers to separate the keyboard from the phone if adhesive is inhibiting removal.

    Aggiungi Commento

    • Remove the four Phillips head screws using the #00 screw driver.

      • You might have to slide the keyboard up or down to access all four screws.

    Aggiungi Commento

    • Lift up slightly on the backing plate.

    • Do not tear the ribbon cables when removing the backing plate. Instead use tweezers to remove them.

    Aggiungi Commento

    • Now you have access to the motherboard.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Michael Giglio

Membro da: 23/04/2012

42 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 7-31, Maness Spring 2012 Membro di Cal Poly, Team 7-31, Maness Spring 2012

CPSU-MANESS-S12S7G31

3 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,528