Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Make sure your Palm Pre is turned off before disassembling the phone.
-
Snap off the back panel to reveal the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pull up on the tab to remove the current battery.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)
-
Use a spudger to pry open the hinge.
-
Use tweezers to disconnect the antennas from the keypad control board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to pry off the (black and yellow) back frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Find the small circuit board at the top right and desolder the wires that are connected to it.
-