Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press the button securing the battery door to the PSP 300xc, and lift the battery door off.
-
Lift the battery out of the PSP.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger or your fingernail to remove the warranty sticker stuck to the inside of the battery tray
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove four Phillips screws from the back of the PSP.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two Phillips screws from the top of the PSP.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove a single screw from the bottom edge of the PSP.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a spudger between the front case and PSP, and slide the spudger along the perimeter of the front case to remove it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove a single Phillips screw securing the home bar to the PSP 300xc.
If you are brave enough steps 7-14 can be avoided, i literally just replaced this power switch skipping 7-14 because the ribbon cable is long and flexible enough to put in, but do not screw the power board into place while doing this makes it a lot easier.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push the home bar to the right about 1cm to release a tab, and begin to lift the right end of the home bar slightly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a spudger under the LCD, beside the black plastic tab.
-
Push the LCD to the left and pry up to release the left edge of the LCD from under the plastic tab.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a spudger under the LCD, beside the black plastic tab.
-
Push the LCD to the right and pry up to release the right edge of the LCD from under the plastic tab.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the LCD away from the PSP to reveal the LCD and home bar ribbon cables.
-
Use your fingernail or the edge of a plastic opening tool to flip up the retaining flap on the following four ZIF connectors:
-
Home bar cable
-
Microphone cable
-
LCD display data cable
-
Touchscreen cable
-
After flipping up the locking tabs on all four connectors, use your fingers or a spudger to gently pull the cables straight out of the connectors.
-
Annulla: non ho completato questa guida.
Altre 10 persone hanno completato questa guida.