PSP 300x Front Casing Replacement

Introduzione

Steps for replacing the outer casing of a Sony PSP-3000.

Cosa ti serve

Passo 1 Battery

PSP 300x Front Casing Replacement, Battery: passo 1, immagine 1 di 3

PSP 300x Front Casing Replacement, Battery: passo 1, immagine 2 di 3

PSP 300x Front Casing Replacement, Battery: passo 1, immagine 3 di 3

Place the PSP face down and locate the battery cover on the left side of the device.
Lift and remove the battery cover to reveal the battery.
Remove the battery.

Modifica

Passo 2 Front Casing

PSP 300x Front Casing Replacement, Front Casing: passo 2, immagine 1 di 1

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

Modifica

This will end your warranty, so do it on your own risk!

Paweł Kasztura - 5 mag 2019 Replica

Even though warranties are long expired on these things.

Vincent C. - 1 apr 2020

“IF” your on this Site “I FIX IT(tm) to lean how to repair something on your own… you “Should NOT” be too concerned about warranty any longer, as if you were .. for your iPhone or Pad etc… you would have taken it to the supplier.. No??

Barry Goian - 25 ott 2020 Replica

Passo 3

Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.
Two are located behind the battery's warranty sticker.
Two are located on the right side of the PSP.

Modifica

Passo 4

Next, unscrew the two screws located at the top of the PSP.

Modifica

Passo 5

Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

Modifica

“DON’T” forget to put your screws separately on a mag mat (Or sticky tape) so to 1) Not loose them & 2) Remember where they go as they may be of differing sizes. (Refer time the pictures also helps, but you can take a pic on your camera as you go to remind you also.

Barry Goian - 25 ott 2020 Replica

Passo 6

Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing. 
Remove the front casing completely.

Modifica

J’ai récemment fait cette réparation et le boîtier avant ne voulait pas venir à condition d’enlever les deux vis sur le boîtier arrière au niveau du joystick et de la croix directionnelle. Il manque donc selon moi une partie mais je peux me tromper !

Valentin Boileau - 6 lug 2020 Replica