Introduzione

Steps for replacing the outer casing of a Sony PSP-3000.

  1. Place the PSP face down and locate the battery cover on the left side of the device.
    • Place the PSP face down and locate the battery cover on the left side of the device.

    • Lift and remove the battery cover to reveal the battery.

    • Remove the battery.

    Aggiungi Commento

  2. Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
    • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

      • Two are located behind the battery's warranty sticker.

      • Two are located on the right side of the PSP.

    Aggiungi Commento

    • Next, unscrew the two screws located at the top of the PSP.

    Aggiungi Commento

    • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

    Aggiungi Commento

    • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


    • Remove the front casing completely.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 16 persone hanno completato questa guida.

kbrunner

Membro da: 05/11/2009

32 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 19-2, Maness Fall 2009 Membro di Cal Poly, Team 19-2, Maness Fall 2009

CPSU-MANESS-F09S19G2

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 17

Ultimi 30 Giorni: 82

Tutti i Tempi: 7,104