Introduzione

If you are having trouble with turning on your PDP Victrix Pro BFG Controller or having trigger problems, this guide will help you. This guide takes you through how to open up your controller, replace your batteries, and replace your triggers. If you have any problems or need to fix anything else related to this controller, please visit our troubleshooting page.

Cosa ti serve

Passo 1 Battery and Trigger

PDP Victrix Pro BFG Battery and Trigger Replacement, Battery and Trigger: passo 1, immagine 1 di 1

Use the purple Module Swap Tool that comes with the device to remove the 4 hex screws.
Remove the joystick/button modules from the controller.

Modifica

Passo 2

Remove the screws from each of the module compartments using a PH0 or J1 bit.

Modifica

Passo 3

Using the iFixit opening tool, gently pry open the two side grips.
Using a PH0 or J1 screwdriver bit with a 4mm diameter or less, remove the screws located in the bottom outside corners.

Modifica

Passo 4

Flip the controller to the other side so the label on the bottom is facing upwards.
On the label, there is a circular icon; this shows the location of a single screw.
Using the same PH0 or J1 screwdriver bit from the previous steps, remove the screw.

Modifica

Passo 5

Flip the controller so the charging port of the controller is facing you.
Using a spudger, carefully pry open the front component.

Modifica

Passo 6

Flip the controller so it is upside-down, but the charging port is still facing you.
In the center of the now exposed part, there will be a hidden silver screw.
Use the flexible piece attached to the screwdriver to remove this screw.
Now that everything is loosened, gently pry open the controller along the grooves.