Salta al contenuto principale

Introduzione

Since replacing the cable requires the use of a soldering iron, there is a risk of burning yourself or damaging the controllers logic board.

  1. Loosen the seven 11 mm Phillips #0 screws located on the back of the controller. Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.
    • Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

  2. Using a plastic opening tool, pry the back cover from the front.
    • Using a plastic opening tool, pry the back cover from the front.

    • The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

  3. Remove the top cover from the bottom and place next to each other.
    • Remove the top cover from the bottom and place next to each other.

  4. Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora

    Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora
  5. Remove the logic board by lifting up on the logic board and pulling out. Remove the logic board by lifting up on the logic board and pulling out.
    • Remove the logic board by lifting up on the logic board and pulling out.

  6. The cable connects to the logic board with a white connector. Above the right joystick, there are four solder pins labeled GND, VCC, DM, and DP.
    • The cable connects to the logic board with a white connector. Above the right joystick, there are four solder pins labeled GND, VCC, DM, and DP.

  7. The soldering iron is very hot and can harm you or the device if used incorrectly.
    • The soldering iron is very hot and can harm you or the device if used incorrectly.

    • Desolder the four pins.

  8. Using your new cable, solder the white connector to the logic board. Be sure to have the cables facing towards the inside of the logic board.
    • Using your new cable, solder the white connector to the logic board. Be sure to have the cables facing towards the inside of the logic board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Jayson Norcross

Membro da: 17/09/2015

240 Reputazione

1 Guida realizzata

Team

IUPUI, Team 3-1, Harley Fall 2015 Membro di IUPUI, Team 3-1, Harley Fall 2015

IUPUI-HARLEY-F15S3G1

4 Membri

5 Guide realizzate

where can I find a replacement cable to perform this precedure with?

Aaron English - Replica

yes!! i would like to know too.. i have been searching for long time for that cable

sokratis162 -

Android cable

Wayne -

U can use a old Android cable

Wayne - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 36

Tutti i Tempi: 4,034