Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Spegni il computer.
-
Aspetta dai 5 ai 10 minuti, il tempo che serve al computer per raffreddarsi.
-
Scollega tutti i cavi esterni (eccetto quello di alimentazione).
-
Tocca il coperchio metallico PCI sul retro, in modo di scaricare l'elettricità statica dal tuo corpo.
-
Scollega il cavo di alimentazione.
-
Indossa un cinturino da polso ESD.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
1) Hold the side access panel and lift the latch on the back of the computer.
-
2) Remove the access panel and place it on a flat surface covered by a soft, clean cloth.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
This procedure explains how to remove a standard card and a card that includes a booster cable. Before you can remove either type of card, however, you must first loosen the two captive screws that secure the PCI bracket to the enclosure and remove the bracket.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
1) Release the small locking clip at the front of the card’s logic board connector by pushing the clip up toward the media shelf.
-
2) Holding the card by the top corners, pull up the card and remove it from its expansion slot.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the booster cable(s) from the logic board.
-
Release the small locking clip at the front of the card’s logic board connector by pushing the clip up toward the media shelf.
-
Holding the card by the top corners, gently pull up the card and remove it from its expansion slot.
-
Annulla: non ho completato questa guida.
Altre 11 persone hanno completato questa guida.
2 Commenti
Wish I had seen this guide a few years ago when I was upgrading my Mac. Would have saved me a few steps.