Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Release the binding straps by lifting up on the buckle and pulling towards the direction of the end of the ladder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Move the straps and the highback plate out of the way in order to have clear access to the foot pad screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips screwdriver to remove the four ovalhead M6 x 12mm screws that attach the base plate of the binding to the board.
-
Lift or slide the binding off the board and set the screws aside.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the snowboard over so the bottom of the board is facing up.
-
Set the snowboard down on a stable work surface so that it does not rock or move.
-
Assess the damage. If there are loose strands of material around the hole, slice them off carefully with a razor blade.
-
Remove any extra wax with a metal scraper.
-
Use 150 grit sandpaper to roughen up the inside of the gouge.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Clean the gouge with a few drops of citrus based cleaner such as Orange-Sol (rubbing alcohol will also work), and a small wire brush to get rid of any dirt or rocks. Let the cleaner dry completely—about 20 minutes to an hour.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a propane torch or a butane lighter, heat up one tip of the P-Tex candle over a metal pan.
-
Wait until the candle is flaming, which may take a couple of seconds.
-
Let the candle drip onto a metal pan and roll the molton tip around until the candle is carbon free.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Move the molten P-Tex candle to the gouge. Hold it close to the surface and let it flow continuously into the gouge surface.
-
The P-Tex will shrink as it cools, so overfill the gouge.
-
Let the P-Tex cool for about 15 minutes.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take a sharpened metal scraper or razor blade and hold it at a 45° angle. Pull the razor using short, overlapping strokes (about a half inch at a time) to remove all material that is protruding above the base of the snowboard. Use whatever direction works best.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
When the P-Tex is smooth and flush with the base, your repair is finished. Take a couple of seconds to admire your work.
-
Wax your board before use.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.