Introduzione

The heating coils may get dirty or in operable with use. This guide will show how to remove the heating coils in order to properly replace or clean them. Prior to replacing the heating coils, ensure that the heating problem is not caused by electrical errors as discussed in the troubleshooting page.

  1. Remove the bread pan.
    • Remove the bread pan.

    Aggiungi Commento

  2. Remove the eight 22mm Phillips #1 screws from the grey lining.
    • Remove the eight 22mm Phillips #1 screws from the grey lining.

    • Remove the grey liner.

    Aggiungi Commento

    • Remove the two 11mm Phillips #1 screws from the back of the device.

    Aggiungi Commento

    • Pop off the top case using a spudger.

    • Keep the spudger away from the control panel.

    • Be aware of wires connecting the microcontroller to the panel when removing the top lining.

    Aggiungi Commento

    • Disconnect microcontroller and top lining.

    • Ground yourself prior to disconnecting in order to avoid harming the inner electronics.

    Aggiungi Commento

    • Remove the four 11mm Phillips #1 screws holding from the guard and inner lining.

    • Remove small rectangular guard from bottom of liner

    Aggiungi Commento

    • Remove the inner liner.

    • The inner liner will be connected to the outer chamber with wires.

    Aggiungi Commento

    • Disconnect the red wires from the inner liner.

    Aggiungi Commento

    • Remove the single 11mm Phillips #1 screw thats holding and inner lining in place.

    Aggiungi Commento

    • Use a spudger to push out the connector found on the inner lining.

    Aggiungi Commento

    • Remove lining.

    Aggiungi Commento

    • Remove the two 11mm Phillips #1 screws from the inside of the chamber.

    • Removal of the screws may also require a 1/4 socket wrench on the other side to prevent spinning.

    Aggiungi Commento

    • Remove the 11mm Phillips #1 screw from the heating coil.

    • After you have removed the screw the coils will pop out of place.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Megan Saunders

Membro da: 25/01/2018

677 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S7-G5, Passmore Spring 2018 Membro di USF Tampa, Team S7-G5, Passmore Spring 2018

USFT-PASSMORE-S18S7G5

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 61