Aggiusta la tua roba Comunità Store

Optical Bay Enclosure Dual Hard Drive Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Introduzione

Universal Prerequisite for Optical Bay Enclosures #78,79,81

  1. Optical Bay Enclosure Dual Hard Drive Replacement, Dual Hard Drive: passo 1, immagine 1 di 2 Optical Bay Enclosure Dual Hard Drive Replacement, Dual Hard Drive: passo 1, immagine 2 di 2

    • Remove the plastic positioner from the optical bay hard drive enclosure by pressing in on one of the clips on either side and lifting it up and out of the enclosure.

    Traduci

  3. Optical Bay Enclosure Dual Hard Drive Replacement: passo 2, immagine 1 di 3 Optical Bay Enclosure Dual Hard Drive Replacement: passo 2, immagine 2 di 3 Optical Bay Enclosure Dual Hard Drive Replacement: passo 2, immagine 3 di 3

    • Make sure that the hard drive connectors are facing down before placing it into the enclosure.

    • Gently place the hard drive into the enclosure's hard drive slot.

    • While firmly holding the enclosure in place with one hand, use your other hand to press the hard drive into the enclosure connectors.

    Traduci

  4. Optical Bay Enclosure Dual Hard Drive Replacement: passo 3, immagine 1 di 2 Optical Bay Enclosure Dual Hard Drive Replacement: passo 3, immagine 2 di 2

    • Once the hard drive is snug, reinsert the plastic positioner while holding the hard drive against the bottom of the enclosure.

    • Reconnect any cables you have removed from the original optical drive onto the optical bay enclosure.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 5 altri collaboratori

Brittany McCrigler

Membro da: 03/05/12

89.011 Reputazione

131 Guide realizzate

Distintivi: 48

+45 altri distintivi

Team

iFixit Membro di iFixit

Staff

135 Membri

16.731 Guide realizzate

Un commento

Great guide, however I think you overestimated the difficulty of it. The biggest challenge is not stripping any screws and being sure to have all sizes that you may possibly need including some that might not be standard because stripping screws is very possible. Otherwise, nice job

Rob Anthony Dire - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 247